Endress+Hauser Proline 200 - Configuring the Totalizer

Commissioning Proline Prowirl F 200 PROFIBUS PA
116 Endress+Hauser
Parameter Prerequisite Description Selection / User
entry
Factory setting
Switch-off delay • The Switch option is
selected in the Operating
mode parameter.
• The Limit option is selected
in the Switch output
function parameter.
Define delay for the switch-off
of status output.
0.0 to 100.0 s 0.0 s
Failure mode – Define output behavior in
alarm condition.
• Actual status
• Open
• Closed
Open
Invert output signal – Invert the output signal. • No
• Yes
No
* Visibility depends on order options or device settings
10.6.5 Configuring the totalizer
In the "Totalizer 1 to 3" submenu the individual totalizer can be configured.
Navigation
"Setup" menu → Advanced setup → Totalizer 1 to 3
‣
Totalizer 1 to 3
Assign process variable
Unit totalizer
Control Totalizer 1 to 3
Totalizer operation mode
Failure mode