Endress+Hauser Proline 200 - 11.7 Showing Data Logging

Operation Proline Prowirl F 200 PROFIBUS PA
132 Endress+Hauser
Function scope of the "Control Totalizer " parameter
Options Description
Totalize The totalizer is started.
Reset + hold The totaling process is stopped and the totalizer is reset to 0.
Preset + hold The totaling process is stopped and the totalizer is set to its defined start value
from the Preset value 1 to 3 parameter.
Stop totalizing option Totalizing is stopped.
Navigation
"Operation" menu → Operation
‣
Totalizer handling
Control Totalizer 1 to 3
Preset value 1 to 3
Parameter overview with brief description
Parameter Prerequisite Description Selection / User
entry
Factory setting
Control Totalizer In the Assign process variable
parameter, one of the
following options is selected:
• Volume flow
• Mass flow
• Corrected volume flow
• Total mass flow
*
• Condensate mass flow
*
• Energy flow
*
• Heat flow difference
*
Control totalizer value. • Totalize
• Reset + hold
• Preset + hold
Totalize
Preset value In the Assign process variable
parameter one of the following
options is selected:
• Volume flow
• Mass flow
• Corrected volume flow
• Total mass flow
• Condensate mass flow
• Energy flow
• Heat flow difference
Specify start value for totalizer. Signed floating-point
number
0 m³
Reset all totalizers – Reset all totalizers to 0 and
start.
• Cancel
• Reset + totalize
Cancel
* Visibility depends on order options or device settings
11.7 Showing data logging
The Extended HistoROM application package must be enabled in the device (order
option) for the Data logging submenu to appear. This contains all the parameters for the
measured value history.
The measured value history is also available via the FieldCare plant asset
management tool →  61.