Endress+Hauser Proline 200 - Configuring the Low Flow Cut off

Commissioning Proline Prowirl F 200 PROFIBUS PA
84 Endress+Hauser
Navigation
"Setup" menu → Communication
‣
Communication
Device address
Parameter overview with brief description
Parameter Description User entry Factory setting
Device address Enter device address. 0 to 126 126
10.5.7 Configuring the low flow cut off
The Low flow cut off wizard guides you systematically through all the parameters that
have to be set for configuring the low flow cut off.
Navigation
"Setup" menu → Low flow cut off
Structure of the wizard
Volume flow
Assign variable
Correct.vol.flow
Reynolds number
Off value
End of wizard
Off
On value
Mass flow
A0020775-EN
 24 "Low flow cut off" wizard in the "Setup" menu