Endress+Hauser Proline 200 - Carrying out a Sensor Adjustment

Proline Prowirl F 200 PROFIBUS PA Commissioning
Endress+Hauser 103
Parameter Prerequisite Description Selection / User
entry
Factory setting
Fixed process pressure The following conditions are
met:
• Order code for "Sensor
version", option "Mass flow
(integrated temperature
measurement)"
• In the External value
parameter (→  102), the
Pressure option is not
selected.
Enter fixed value for process
pressure.
Dependency
The unit is taken from the
Pressure unit parameter

For detailed information
on the calculation of the
measured variables with
steam: →  186

For detailed information
on setting the parameter
in steam applications,
see the Special
Documentation for the
Wet Steam Detection
and Wet Steam
Measurement
→  212 application
package.
0 to 250 bar abs. 0 bar abs.
Steam quality The following conditions are
met:
• Order code for "Application
package":
– Option ES "Wet steam
detection"
– Option EU "Wet steam
measurement"
• In the Select medium
parameter, the Steam
option is selected.

The software options
currently enabled are
displayed in the
Software option
overview parameter.
Select compensation mode for
steam quality.

For detailed information
on setting the parameter
in steam applications,
see the Special
Documentation for the
Wet Steam Detection
and Wet Steam
Measurement
→  212 application
package.
• Fixed value
• Calculated value
Fixed value
Steam quality value The following conditions are
met:
• In the Select medium
parameter, the Steam
option is selected.
• In the Steam quality
parameter, the Fixed value
option is selected.
Enter fixed value for steam
quality.

For detailed information
on setting the parameter
in steam applications,
see the Special
Documentation for the
Wet Steam Detection
and Wet Steam
Measurement
→  212 application
package.
0 to 100 % 100 %
10.6.3 Carrying out a sensor adjustment
The Sensor adjustment submenu contains parameters that pertain to the functionality of
the sensor.
Navigation
"Setup" menu → Advanced setup → Sensor adjustment
‣
Sensor adjustment
Inlet configuration