Endress+Hauser Proline 200 - Page 117

Proline Prowirl F 200 PROFIBUS PA Commissioning
Endress+Hauser 117
Parameter overview with brief description
Parameter Prerequisite Description Selection Factory setting
Assign process variable – Select process variable for
totalizer.
• Volume flow
• Mass flow
• Corrected volume
flow
• Total mass flow
*
• Condensate mass
flow
*
• Energy flow
*
• Heat flow
difference
*
• Totalizer 1:
Volume flow
• Totalizer 2: Mass
flow
• Totalizer 3:
Corrected volume
flow
Unit totalizer In the Assign process variable
parameter, one of the
following options is selected:
• Volume flow
• Mass flow
• Corrected volume flow
• Total mass flow
*
• Condensate mass flow
*
• Energy flow
*
• Heat flow difference
*
Select the unit for the process
variable of the totalizer.
Unit choose list m³
Control Totalizer 1 to 3 In the Assign process variable
parameter, one of the
following options is selected:
• Volume flow
• Mass flow
• Corrected volume flow
• Total mass flow
*
• Condensate mass flow
*
• Energy flow
*
• Heat flow difference
*
Control totalizer value. • Totalize
• Reset + hold
• Preset + hold
Totalize
Totalizer operation mode In the Assign process variable
parameter, one of the
following options is selected:
• Volume flow
• Mass flow
• Corrected volume flow
• Total mass flow
*
• Condensate mass flow
*
• Energy flow
*
• Heat flow difference
*
Select totalizer calculation
mode.
• Net flow total
• Forward flow total
• Reverse flow total
• Last valid value
Net flow total
Failure mode In the Assign process variable
parameter, one of the
following options is selected:
• Volume flow
• Mass flow
• Corrected volume flow
• Total mass flow
*
• Condensate mass flow
*
• Energy flow
*
• Heat flow difference
*
Define the totalizer behavior in
the event of a device alarm.
• Stop
• Actual value
• Last valid value
Actual value
* Visibility depends on order options or device settings