Endress+Hauser Proline Promag 10 - Turning the Local Display; Affixing the Local Display to the Blind Version

3 Installation PROline Promag 10
32 Endress+Hauser
3.3.5 Turning the local display
1. Unscrew cover of the electronics compartment from the transmitter housing.
2. Remove the display module from the transmitter retainer rails.
3. Turn the display to the desired position (max. 4 x 45° in each direction) and reset it
onto the retaining rails.
4. Screw the cover of the electronics compartment firmly back onto the transmitter
housing.
Fig. 22: Rotating the local display
3.3.6 Affixing the local display to the blind version
A local display can be temporarily affixed to devices which do not have a local display.
1. Switch off power supply.
2. Remove the cover of the electronics compartment.
3. Affix local display.
4. Switch on power supply.
4 x 45°
Esc
–
+
E
F06-72xxxxxx-07-xx-06-xx-000