5 Operation PROline Promag 10
48 Endress+Hauser
5Operation
5.1 Display and operating elements
The local display enables you to read all important parameters directly at the measuring
point and also configure the device.
The display area consists of two lines; this is where measured values and/or status
variables (partially filled pipe) are displayed. The assignment of the display lines in
operating mode is specified. The top line displays the volume flow and the bottom line
displays the totalizer status.
Fig. 35: Display and operating elements
Liquid crystal display (1)
The unilluminated, two-line liquid crystal display shows measured values, dialog texts, fault messages and
notice messages. The display as it appears during standard measuring mode is known as the HOME position
(operating mode).
Top line: shows main measured values, volume flow, e.g. in [ml/min]
Bottom line: shows the totalizer status, e.g. in [m
3
],
Push buttons (2)
– Enter numerical values, select parameters
– Select different function groups within the function matrix
Press the +/
− keys simultaneously to trigger the following functions:
– Exit the function matrix step by step
→ HOME position
– Press and hold down the +/
− keys for more than 3 seconds → Return directly to HOME position
– Cancel data entry
Enter push button (3)
–HOME position
→ Enter the function matrix
– Save the numerical values you input or settings you changed
Esc
E
+
-
1
32
+48.25 ml/min
+3702.6 m
3
F06-50xxxxxx-07-xx-xx-xx-000
To Next Page
Loading...
