9 Trouble-shooting PROline Promag 10
72 Endress+Hauser
9.6 Spare parts
Section 9.1 contains detailed trouble-shooting instructions. The measuring device,
moreover, provides additional support in the form of continuous self-diagnosis and error
messages.
Trouble-shooting can entail replacing defective components with tested spare parts.
The illustration below shows the available scope of spare parts.
!
Note!
You can order spare parts directly from your E+H service organisation by providing the
serial number printed on the nameplates (see Page 7).
Spare parts are shipped as sets comprising the following parts:
• Spare part
• Additional parts, small items (threaded fasteners, etc.)
• Installation instructions
• Packaging
Fig. 39: Spare parts for Promag 10 transmitter
1 Electronics board (85...250 V AC or 20...28 V AC / 11...40 V DC)
2 Display module
Esc
2
1
F06-10xxxxxx-03-06-06-xx-000
To Next Page
Loading...
