Endress+Hauser Proline Promag 10 - Accessories; Transmitter, Cables, and Grounding Accessories; Mounting Kits and Connection Accessories

8 Accessories PROline Promag 10
64 Endress+Hauser
8 Accessories
Various accessories, which can be ordered separately from Endress+Hauser, are
available for the transmitter and the sensor. Your E+H service organisation can provide
detailed information on the order codes of your choice.
Accessory Description Order code
Promag 10 transmitter Transmitter for replacement or for stock. Use
the order code to define the following
specifications:
–Approvals
– Degree of protection / version
– Cable type for remote version
– Cable entry
– Display / power supply / operation
– Software
– Outputs / inputs
10XXX
− XXXXX * * * * * * * *
Cable for remote
version
Coil and signal cables in various lengths. DK5CA − * *
Ground cable for
Promag W, P
A set consists of two ground cables. DK5GC
− * * *
Ground disk for
Promag W, P
Ground disk for potential equalisation DK5GD – * * ***
Mounting kit for remote
version, aluminium
housing
Mounting kit for remote version, suitable for
pipe and wall mounting
DK5WM – B
Mounting kit for
Promag H
Mounting kit for Promag H comprising:
– 2 process connections
– Threaded fasteners
– Seals
DKH * *
− * * *
Adapter connection for
Promag A, H
Adapter connections for installing
Promag 10 H instead of a Promag 30/33 A or
Promag 30/33 H DN 25.
DK5HA
− * * * * *
Sealing kit for Promag H For regular replacement of the seals of the
Promag H sensor.
DK5HS
− * * *
Promag H wall
mounting kit
Wall mounting kit for Promag H sensor DK5HM-**
Welding jig for
Promag H
Weld nipple as process connection:
Welding jig for installation in pipe.
DK5HW
− * * *
HART Communicator
DXR 275 handheld
terminal
Handheld terminal for remote configuration
and for obtaining measured values via the
current output HART (4...20 mA).
Contact your E+H representative for more
information.
DXR275
− * * * *