Endress+Hauser Proline Promag W 800 - Page 118

Technical data Proline Promag W 800
118 Endress+Hauser
designated standards. By selecting the order option for UKCA marking, Endress+Hauser
confirms a successful evaluation and testing of the device by affixing the UKCA mark.
Contact address Endress+Hauser UK:
Endress+Hauser Ltd.
Floats Road
Manchester M23 9NF
United Kingdom
www.uk.endress.com
RCM marking The measuring system meets the EMC requirements of the "Australian Communications
and Media Authority (ACMA)".
Drinking water approval • ACS
• KTW/W270
• NSF 61
• WRAS BS 6920
Radio approval The measuring device has radio approval.
For detailed information on the radio approval, see the Special Documentation
→  120
Pressure Equipment
Directive
• With the marking
a) PED/G1/x (x = category) or
b) PESR/G1/x (x = category)
on the sensor nameplate, Endress+Hauser confirms compliance with the "Essential
Safety Requirements"
a) specified in Annex I of the Pressure Equipment Directive 2014/68/EU or
b) Schedule 2 of Statutory Instruments 2016 No. 1105.
• Devices not bearing this marking (without PED or PESR) are designed and manufactured
according to sound engineering practice. They meet the requirements of
a) Art. 4 Para. 3 of the Pressure Equipment Directive 2014/68/EU or
b) Part 1, Para. 8 of Statutory Instruments 2016 No. 1105.
The scope of application is indicated
a) in diagrams 6 to 9 in Annex II of the Pressure Equipment Directive 2014/68/EU or
b) Schedule 3, Para. 2 of Statutory Instruments 2016 No. 1105.
Measuring instrument
approval
The measuring device is (optionally) approved as a cold water meter (MI‐001) for volume
measurement in service subject to legal metrological control in accordance with the
European Measuring Instruments Directive 2014/32/EU (MID).
The measuring device is qualified according to OIML R49: 2013.
External standards and
guidelines
• EN 60529
Degrees of protection provided by enclosure (IP code)
• EN 61010-1
Safety requirements for electrical equipment for measurement, control and laboratory
use - general requirements
• IEC/EN 61326-2-3
Emission in accordance with Class A requirements. Electromagnetic compatibility (EMC
requirements).
• ANSI/ISA-61010-1 (82.02.01)
Safety Requirements for Electrical Equipment for Measurement, Control and Laboratory
Use - Part 1 General Requirements