Endress+Hauser Proline Promag W 800 - Transmitter Nameplate; Sensor Nameplate

Incoming acceptance and product identification Proline Promag W 800
16 Endress+Hauser
For an overview of the scope of the associated Technical Documentation, refer to the
following:
• The "Additional standard device documentation" →  120 and "Supplementary device-
dependent documentation" sections→  120
• The Device Viewer: Enter the serial number from the nameplate
(www.endress.com/deviceviewer)
• The Endress+Hauser Operations app: Enter the serial number from the nameplate or
scan the DataMatrix code on the nameplate.
4.2.1 Transmitter nameplate
• Name of the transmitter
• Manufacturer address/certificate holder
• Order code
• Serial number
• Extended order code
• Firmware version (FW) and device revision (Dev.Rev.) from the factory
• Permitted ambient temperature (T
a
)
• FCC-ID (Federal Communications Commission)
• Degree of protection
• Permitted temperature range for cable
• 2-D matrix code
• Date of manufacture: year-month
• FCC mark
• CE mark, RCM-Tick mark
• Electrical connection data, e.g. available inputs and outputs, supply voltage
4.2.2 Sensor nameplate
• Name of sensor
• Manufacturer address/certificate holder
• Order code
• Serial number
• Extended order code
• Nominal diameter of the sensor
• Test pressure of the sensor
• Medium temperature range
• Material of liner and electrodes
• Degree of protection: e.g. IP, NEMA
• Permitted ambient temperature (T
a
)
• 2-D matrix code
• CE mark, RCM-Tick mark
• Flow direction
• Date of manufacture: year-month
Order code
The measuring device is reordered using the order code.
Extended order code
• The device type (product root) and basic specifications (mandatory features) are
always listed.
• Of the optional specifications (optional features), only the safety and approval-
related specifications are listed (e.g. LA). If other optional specifications are also
ordered, these are indicated collectively using the # placeholder symbol (e.g. #LA#).
• If the ordered optional specifications do not include any safety and approval-related
specifications, they are indicated by the + placeholder symbol (e.g. XXXXXX-ABCDE
+).