Endress+Hauser Proline Promag W 800 - Filtering the Event Logbook; Overview of Information Events

Proline Promag W 800 Diagnosis and troubleshooting
Endress+Hauser 83
In addition to the operating time when the event occurred, each event is also assigned a
symbol that indicates whether the event has occurred or is finished:
• Diagnostics event
• : Occurrence of the event
• : End of the event
• Information event
: Occurrence of the event
To call up the measures to rectify a diagnostic event:
Via SmartBlue App
For filtering the displayed event messages →  83
12.7.2 Filtering the event logbook
Using the Filter options parameter you can define which category of event message is
displayed in the Events list submenu.
Navigation path
Diagnostics → Event logbook → Filter options
Filter categories
• All
• Failure (F)
• Function check (C)
• Out of specification (S)
• Maintenance required (M)
• Information (I)
12.7.3 Overview of information events
Unlike a diagnostic event, an information event is displayed in the event logbook only and
not in the diagnostic list.
Info number Info name
I1000 --------(Device ok)
I1079 Sensor changed
I1089 Power on
I1090 Configuration reset
I1091 Configuration changed
I11036 Date/time set successfully
I11068 Device ok
I11095 Device ok
I1137 Display module replaced
I1151 History reset
I1155 Reset electronics temperature
I1157 Memory error event list
I1256 Display: access status changed
I1335 Firmware changed
I1351 Empty pipe detection adjustment failure
I1353 Empty pipe detection adjustment ok
I1397 Fieldbus: access status changed
I1398 CDI: access status changed
I1444 Device verification passed