Endress+Hauser Proline Promag W 800 - Access Via Bluetooth Wireless Technology

Safety instructions Proline Promag W 800
12 Endress+Hauser
2. Set the write protection (WP) switch on the display module to the ON position.
 Hardware write protection is enabled.
In the Locking status parameter, the Hardware locked option is displayed.
On the local display, the  symbol appears in the header.
V
.
8.3
m /min
3
A0044218
3.
L
WARNING
Excessive tightening torque applied to the fixing screws!
Risk of damaging the plastic transmitter.
‣
Tighten the fixing screws as per the tightening torque →  33.
Reassemble the transmitter in the reverse order.
2.7.3 Access via Bluetooth® wireless technology
Secure signal transmission via Bluetooth® wireless technology uses an encryption
method tested by the Fraunhofer Institute.
• The device is not visible via Bluetooth® wireless technology without the SmartBlue App.
• Only one point-to-point connection is established between the device and a smartphone
or tablet.
• It is possible to configure the Bluetooth® wireless technology interface in such a way that
Bluetooth® is only active (the device is only then visible) if the display is activated onsite
via Wake on Touch.