Engine distributors DSG-423 User Manual

DSG-423 COOLING SYSTEM
05-11
Radiator Hose - Removal
WARNING: REFER TO CAUTIONS AND WARNINGS
AT THE BEGINNING OF THIS SECTION.
1. Drain the cooling system -- Refer to“Draining the
Cooling System” on page 9 of this section.
2. Loosen the clamps at each end of the hose to be
removed.
3. Slide the hose off the radiator connection and the
engine water outlet connection.
Radiator Hose - Installation
1. Position the clamps at least 1/8 inch from each end
of the hose.
2. Coat the connection areas with an approved water-
resistant sealer and slide the hose on the
connection.
NOTE: Make sure the clamps are beyond the bead and
placed in the center of the clamping surface of the
connections.
3. Tighten the clamps.
4. Fill the system with coolant -- Refer to“Filling the
Cooling System” on page 9 of this section.
5. Operate the engine for several minutes, then check
the hoses and connections for leaks.
Upper Hose
Lower Hose

Engine distributors DSG-423 Specifications

General

Brand	Engine distributors
Model	DSG-423
Category	Engine
Language	English