EasyManuals Logo

Engine distributors DSG-423 User Manual

Engine distributors DSG-423
240 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #222 background imageLoading...
Page #222 background image
DSG-423 ENGINE CONTROLS
08-45
Cylinder Head Temperature (CHT) Sensor -
Replacement
1. Disconnect battery ground cable -- refer to section 6.
2. Remove or disconnect any component to allow
access and removal of the CHT Sensor.
3. Pull back the CHT sensor cover and disconnect
electrical connector.
4. Remove the CHT Sensor.
5. Reverse procedure to install:
Tighten CHT sensor to 12 Nm (9 lb-ft).
Engine Coolant Temperature (ECT) Sensor
- Replacement
(??need procedure??)
Heated Oxygen Sensor (HO2S) -
Replacement
1. Disconnect battery ground cable -- refer to section 6.
2. Remove or disconnect any component to allow
access and removal of the HO2S Sensor.
3. Disconnect HO2S electrical connector.
NOTE: Use penetrating oil to assist in removal.
4. Remove HO2S sensor using special tool 303-476.
5. Reverse procedure to install:
Apply a light coat of anti-seize lubricant to the
threads of the sensor.
Tighten sensor to 40 Nm (30 lb-ft).
Boot
CHT Sensor
HO2S Sensor

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Engine distributors DSG-423 and is the answer not in the manual?

Engine distributors DSG-423 Specifications

General IconGeneral
BrandEngine distributors
ModelDSG-423
CategoryEngine
LanguageEnglish

Related product manuals