Engine distributors DSG-423 User Manual

DSG-423 ENGINE
02-23
Oil Filter Adapter - Removal
1. Disconnect negative battery cable -- refer to Section
6.
2. Remove and/or disconnect components to allow
access and removal of the oil filter adapter. Label if
necessary to allow for correct reinstallation.
3. Drain the engine oil.
4. Disconnect the oil pressure sender connector.
5. Remove the oil pressure sender -- Refer to“Oil
Pressure Sender - Replacement” on page 23 of this
section.
6. Remove and discard the oil filter.
7. Remove 4 bolts and oil filter adapter.
8. Remove and discard the gasket.
Oil Filter Adapter - Installation
CAUTION: Do not use metal scrapers, wire brushes,
power abrasive discs or other abrasive means to
clean the sealing surfaces. These tools cause
scratches and gouges which make leak paths. Use
a plastic scraping tool to remove all traces of old
sealant.
1. Clean the mating surface of adapter and block, with
silicone gasket remover and metal surface prep.
WARNING: OBSERVE ALL WARNINGS AND
CAUTIONS AND FOLLOW ALL APPLICATION
DIRECTIONS CONTAINED ON THE PACKAGING OF
THE SILICONE GASKET REMOVER AND METAL
SURFACE PREP.
2. Using a new gasket, install the oil filter adapter and
4 bolts:
• Tighten to 25 Nm (18 lb-ft).
3. Install a new oil filter.
4. Apply thread sealant with PTFE to the oil pressure
sender threads and install the sender:
5. Tighten to 15 Nm (11 lb-ft).
6. Connect oil pressure sender connector.
7. Fill the engine with clean engine oil.
8. Run the engine and check for leaks.
9. Install or reconnect any other component that was
removed or disconnected.
Oil Pressure Sender - Replacement
1. Disconnect negative battery cable -- refer to Section
6.
2. Remove and/or disconnect components to allow
access and removal of the oil pressure sender.
Label if necessary to allow for correct reinstallation.
3. Disconnect the oil pressure sender connector.
4. Remove the oil pressure sender.
5. Apply thread sealant with PTFE to the oil pressure
sender threads and install the sender:
6. Tighten to 15 Nm (11 lb-ft).
7. Connect oil pressure sender connector.
Adapter
Filter
Bolts
Oil Pressure
Sender

Engine distributors DSG-423 Specifications

General

Brand	Engine distributors
Model	DSG-423
Category	Engine
Language	English