Epson AcuLaser MX14 - Margin Top;Bottom

❏ “Making Copies From the Document Glass” on page 116
2. Press the
(Copy) button.
3. Select Multiple Up, and then press the
button.
4. Select the desired setting, and then press the
button.
Note:
Value marked by an asterisk (*) is the factory default menu settings.
Off*
Does not perform Multiple Up printing.
Auto
Automatically reduces the original pages to fit onto one sheet of paper.
ID Card Copy
Prints the original pages onto one sheet of paper in the original size.
Manual
Prints the original pages onto the one sheet of paper in the size specified in
Reduce/Enlarge.
5. If necessary, customize the copy settings including the number of copies, copy size (only for Off or
Manual), and image quality.
See Also:
“Setting Copy Options” on page 119
6. Press the
(Start) button to begin copying.
When you are using the document glass and Multiple Up is set to Auto, ID Card Copy, or
Manual, the display prompts you for another page. Select Yes or No, and then press the
button.
If you select Yes, select Continue or Cancel, and then press the
button.
Margin Top/Bottom
You can specify the top and bottom margins of the copy.
1. For the Epson AcuLaser MX14NF, load the document(s) face up with top edge in first into the
ADF or place a single document face down on the document glass, and close the document cover.
For the Epson AcuLaser MX14, place a single document face down on the document glass, and
close the document cover.
Epson AcuLaser MX14 Series User’s Guide
Copying 129