Note:
If the problem continues even though you have taken suggested actions described above, contact the
Epson local representative office or an authorised dealer.
Bead-Carry-Out (BCO)
Problem Action
Bead-Carry-Out (BCO) is happening. If the printer is installed in a high altitude location, set the altitude of the location.
1. Launch the Printer Setting Utility, and click Adjust Altitude on the Printer
Maintenance tab.
2. Select the value close to the altitude of the location where the printer is installed.
3. Click Apply New Settings button.
Note:
If the problem continues even though you have taken suggested actions described above, contact the
Epson local representative office or an authorised dealer.
Auger Mark
Epson AcuLaser MX14 Series User’s Guide
Troubleshooting 277
To Next Page
Loading...
