Epson AcuLaser MX14 - Protrudent;Bumpy Paper; Copy Problem

Note:
If the problem continues even though you have taken suggested actions described above, contact the
Epson local representative office or an authorised dealer.
Protrudent/Bumpy Paper
Problem Action
Printed surface got protrudent/bumpy. Clean up the fusing unit.
1. Load one sheet of paper on the MPF, and then print a solid image all over paper.
2. Load the printed sheet with the side to be printed on facing down, and then print
a blank sheet of paper.
Note:
If the problem continues even though you have taken suggested actions described above, contact the
Epson local representative office or an authorised dealer.
Copy Problem
Problem Action
(Epson AcuLaser MX14NF only)
A document loaded in the ADF cannot
be copied.
Ensure that the ADF cover is firmly closed.
Epson AcuLaser MX14 Series User’s Guide
Troubleshooting 280