Epson AcuLaser MX14 - Page 210

Speed Dial
Purpose:
To store up to 99 frequently dialed numbers in speed dial locations.
Note:
The first eight entries are assigned to the one-touch buttons on the operator panel.
See Also:
“Storing a Number for Speed Dialing” on page 193
Group Dial
Purpose:
To create a group of fax destinations and register it under a 2-digit dial code. Up to 6 group dial codes
can be registered.
See Also:
“Setting Group Dial” on page 195
Network (Epson AcuLaser MX14NF Only)
Use the Network menu to change the printer settings affecting jobs sent to the printer through the
network.
Note:
Values marked by an asterisk (*) are the factory default menu settings.
Ethernet
Purpose:
To specify the communication speed and the duplex settings of Ethernet. The change becomes
effective after the printer is turned off and then on.
Values:
Auto*
Detects the Ethernet settings automatically.
10BASE-T Half
Uses 10base-T half-duplex.
10BASE-T Full
Uses 10base-T full-duplex.
100BASE-TX Half
Uses 100base-TX half-duplex.
100BASE-TX Full
Uses 100base-TX full-duplex.
Epson AcuLaser MX14 Series User’s Guide
Using the Operator Panel Menus and Keypad 210