Epson AcuLaser MX14 - Page 212

WSD Disable
Disables the WSD port.
Enable*
Enables the WSD port.
SNMP Disable
Disables the Simple Network Management Protocol (SNMP) UDP port.
Enable*
Enables the SNMP UDP port.
StatusMessenger Disable
Disables the StatusMessenger feature.
Enable*
Enables the StatusMessenger feature.
InternetServices Disable
Disables an access to EpsonNet Config embedded in the printer.
Enable*
Enables an access to EpsonNet Config embedded in the printer.
LLTD Disable
Disables the LLTD.
Enable*
Enables the LLTD.
Bonjour(mDNS) Disable
Disables the Bonjour (mDNS).
Enable*
Enables the Bonjour (mDNS).
Initialize NVM
Purpose:
To initialize network data stored in Non-Volatile Memory (NVM). After executing this function and
rebooting the printer, all network settings are reset to their default values.
Values:
Yes
Initializes the wired network data stored in NVM.
No*
Does not initialize the wired network data stored in NVM.
Fax Settings (Epson AcuLaser MX14NF Only)
Use the Fax Settings menu to configure the basic fax settings.
Note:
Values marked by an asterisk (*) are the factory default menu settings.
Ans Select
Purpose:
To select the default fax receiving mode.
Epson AcuLaser MX14 Series User’s Guide
Using the Operator Panel Menus and Keypad 212