❏ If envelopes are still not fed correctly, add some bending to the flap of the envelopes as shown in the
following illustration.
The amount of the bending shall be 5 mm (0.20 inches) or less.
❏ To confirm the correct orientation of each print media such as envelopes, see the instruction on the
Envelope/Paper Setup Navigator on the print driver.
Loading Postcard in the Multipurpose Feeder (MPF)
Note:
When you print on postcards, be sure to specify the postcard setting on the print driver to get the optimum
print result.
Epson AcuLaser MX14 Series User’s Guide
Printing Basics 83
To Next Page
Loading...
