5. Load the originals with the side to be scanned facing up and in descending order of paper size with the widest
at the back and the narrowest at the front of the input tray.
c
Important:
Check the following points when setting dierent sizes of originals.
❏ Slide the originals with their leading edges aligned, until they meet resistance in the ADF.
❏ Set the originals at the center of the input tray. Refer to the
u
mark on the scanner as your guide.
❏ Set the originals straight.
If not, originals may be fed askew or jammed.
6. Align the edge guides with the widest original.
Placing Originals
>
Placing Originals in the Scanner
>
Loading Batches of Originals with Dierent Paper Types an
…
86
To Next Page
Loading...
