3. Open the front paper guide by pulling the tab at the center
of the guide. Slide the left edge guide as shown below.
(Printing starts at the arrow mark.) Next adjust the right
edge guide to match the width of your paper.
4. Set the paper release lever to the single-sheet position. Also set
the paper thickness lever (located under the printer cover) to
the proper position for your paper’s thickness. (See the table
on page 3-3.)
5. Press the
Operate
button to turn on the printer, if necessary.
2-11nn
2-10a
3
Sun-G+ Rev.C
A5 size Chapter 3
97/11/14 pass 1
Printing on Single Sheets 3-11
To Next Page
Loading...
Need help?
General
