Character table
You can select among 11 standard character tables as well as
tables for 19 other countries. See Appendix C for character
samples.
International character set for Italic table
You can select among several international character sets for
the Italic character table. Each character set contains eight
characters that vary depending on the country or language, so
you can customize the Italic table to suit your printing needs.
See Appendix C for character samples.
0 slash
When you turn on this setting, the zero character contains a
slash (0); otherwise it has no slash (0). The slash allows you to
easily distinguish between the uppercase letter “O” and a zero.
High speed draft
When you choose On, the printer prints up to 500 cps
(characters per second) at 10 cpi (characters per inch). When
you choose Off, the printer prints up to 455 cps at 12 cpi.
Input buffer
When you turn on this setting, the printer’s input buffer stores
up to 64KB of data sent from your computer, freeing up your
computer for other tasks while the printer prints. When you
select Off, the buffer cannot store data, so the computer must
wait for the printer to print each character before it sends the
next character.
Buzzer (beeper)
When you turn on this setting, the printer beeps when an error
occurs. See page 7-2 for more information on printer errors. If
you do not want the printer to beep when an error occurs,
select Off.
5
R
Sun-G+ Rev.C
A5 size Chapter 5
97/11/13 pass 0
Changing Printer Settings From the Printer’s Control Panel 5-7
To Next Page
Loading...
Need help?
General
