1. Make sure paper is loaded and the printer is turned off.
c
Caution:
Whenever you turn off the printer, wait at least five seconds
before turning it back on; otherwise you may damage the
printer.
2. Hold down the
Pitch button while you press the Operate
button to turn on the printer. The printer enters the
default-setting mode and prints the language selection
instructions (one page).
3. Press the
Pitch button until the Pitch lights indicate the
language you want, as described in the language selection
instructions.
4. Press the
Font button to print the default-setting mode
instructions (two pages) in the language you selected.
The printed instructions list the default settings you can change,
describe how to change them, and show you how the control
panel lights help you make settings. Follow these instructions
to change the default settings using the buttons on the
printer’s control panel.
Note:
The arrows on the instruction sheets indicate the printer’s current
settings.
5. When you finish making settings, press the
Operate button to
turn off the printer and exit the default-setting mode. Any
settings you have made remain in effect until you change them
again.
Note:
You may exit the default-setting mode by turning off the printer while
the printer is not printing.
5
R
Sun-G+ Rev.C
A5 size Chapter 5
97/11/13 pass 0
Changing Printer Settings From the Printer’s Control Panel
5-9
To Next Page
Loading...
Need help?
General
