The printer does not fully eject a single sheet.
Cause What to do
Your paper is too long. Press the Load/Eject button to eject
the sheet. Make sure the page length
of your paper is within the range
specified for single-sheet paper in
Appendix C. Also check and adjust the
paper size setting in your application
or printer driver.
The optional cut-sheet feeder does not feed your single-sheet
paper properly.
Cause What to do
The cut-sheet feeder is not
installed properly.
Reinstall it as described in Appendix A.
Too many sheets are loaded in
the cut-sheet feeder.
Load no more than 150 single sheets in
the high-capacity cut-sheet feeder. See
“Using the Optional Cut-Sheet
Feeders” in Appendix A for more
information.
The edge guides of the
cut-sheet feeder are not
positioned correctly.
Align the left edge guide with the
arrow mark, then move the right edge
guide to match your paper’s width.
There is only one sheet left in
the bin.
Load more paper in the cut-sheet
feeder.
7
Troubleshooting
R
Sun-G+ Rev.C
A5 size Chapter 7
97/11/14 pass 1
Troubleshooting 7-7
To Next Page
Loading...
Need help?
General
