Tractor position Description
front push
To use this tractor, load paper in the front slot. If you
print on thick paper such as multi-part forms or
continuous paper with labels, load the paper in the
front paper slot because the paper path from this
slot is almost straight. This reduces the chance of
paper jams.
rear push
To use this tractor, load paper in the rear slot. When
you print on multi-part forms that are bound on only
one side by point glueing, load them in the rear
paper slot; the front push tractor cannot feed this
type of form.
Note:
Because thick multi-part forms require a straight
paper path, load them in the front slot.
Caution:
Do not load continuous paper with labels in the rear
slot. If you load continuous paper with labels in the
rear slot, the labels may come off their backing
sheet inside the printer and cause a paper jam.
Using a pull tractor
If you often print on thick or heavy continuous paper, such as
multi-part forms or continuous paper with labels, use a tractor
in the pull position. The pull tractor provides the best paper
jam prevention, and allows you to load continuous paper from
the front, rear, or bottom of the printer. However, you cannot
use the tear-off feature with the pull tractor.
Note:
If you plan to use a pull tractor, you can remove the tractor from the
front push position and install it in the pull position, or you can
purchase the optional pull tractor (C80032]) and install it in the pull
position. See Chapter 2 for instructions.
g2-8aa1
g2-8aa4
R
Sun-G+ Rev.c
A5 size Introduction
97/11/14 pass 0
Getting to Know Your Printer 5
To Next Page
Loading...
Need help?
General
