6. As shown below, set the cut-sheet feeder’s paper type levers to the
proper position for the paper you will load: single-sheet paper or
postcards and envelopes.
Note:
Always set the paper type levers before you load paper.
7. Pull both paper set levers forward until the paper guides retract
and lock open to allow paper loading.
8. Take a stack of paper (up to 150 sheets of plain paper) and fan it.
Next, tap the side and bottom edges of the paper on a flat surface to
even up the stack.
9. Insert the paper stack printable side down along the left paper guide.
single-sheet paper or
single-sheet multi-part
forms
envelopes or postcards
4-3
4-3aa
L
Sun-G+ Rev.C
A5 size Appendix A
97/11/14 pass 1
A-8 Enhancing Your Printer With Options
To Next Page
Loading...
Need help?
General
