7. Place the shaft and paper roll on the roll paper holder so the paper
feeds from the bottom of the roll.
8. Turn on the printer. Then bring the leading edge of the paper up over
the rear push tractor and insert it until it meets resistance. The printer
loads the roll paper automatically.
9. Replace the paper guide and close the paper guide cover. You are now
ready to print. The printed roll paper is fed over the paper guide to
the back of the printer, as shown below.
g3-32-2
4-9
A
R
Sun-G+ Rev.C
A5 size Appendix A
97/11/14 pass 1
Enhancing Your Printer With Options A-15
To Next Page
Loading...
Need help?
General
