Use the following table to set the paper thickness lever to
match the thickness of your paper.
Paper type* Lever position
Ordinary (single sheets or continuous paper) 0
Thin paper -1 or 0
Carbonless multi-part forms with:
2 parts (original + 1 copy)
3 parts (original + 2 copies)
4 parts (original + 3 copies)
5 parts (original + 4 copies)
6 parts (original + 5 copies)
7 parts (original + 6 copies)**
1
3
4
5
6
6
Continuous paper with labels 2
Envelopes 4 or 5
Postcards 3
* See Appendix C for complete paper specifications.
**Always load multi-part forms with seven parts (one original plus six copies)
from the front or bottom slot onto the pull tractor.
Note:
R If the printed image is smeared, you may need to set the paper
thickness lever one position lower to improve print quality.
R If the printed image is faint or has many gaps, you may need to
set the paper thickness lever one position higher to improve print
quality.
L
Sun-G+ Rev.C
A5 size Chapter 2
97/11/17 pass 3
2-4
Printing on Continuous Paper
To Next Page
Loading...
