The table below shows the types of paper you can load in the
top and front paper slots and the paper thickness lever settings
for each paper type. For more information on the paper
thickness lever, see page 2-3.
Paper type Available
paper slots
Paper thickness
lever position
Ordinary single-sheet paper Top and front -1 or 0
Multi-part forms (carbonless)
2 parts (original + 1 copy)
3 parts (original + 2 copies)
4 parts (original + 3 copies)
5 parts (original + 4 copies)
6 parts (original + 5 copies)
Top and front
1
3
4
5
6
Postcards Top and front 3
Envelopes Top 4 or 5
Note:
R If the printed image is smeared, you may need to set the paper
thickness lever one position lower to improve print quality.
R If the printed image is faint or has many gaps, you may need to
set the paper thickness lever one position higher to improve print
quality.
R Do not load paper that is damaged, curled or has been folded.
3
Sun-G+ Rev.C
A5 size Chapter 3
97/11/14 pass 1
Printing on Single Sheets
3-3
To Next Page
Loading...
Need help?
General
