Insert this type of form in the front slot with the bound edge first
and the printable side up, as shown below.
T
You can load multi-part forms bound at the side only in the
front slot. Insert this type of form in the front slot with the
top edge first and the printable side up, as shown below.
T
Before printing, set the paper thickness lever (located under
the printer cover) to the proper position for your paper. See
the table on page 3-3.
T
Be sure your multi-part forms do not exceed 0.46 mm
(0.018 inch) in thickness.
T
Use multi-part forms only under normal temperature and
humidity conditions, as follows:
Temperature 15 to 25°C (59 to 77°F)
Humidity 30 to 60% RH
printable side up
new05
printable side up
NEW07
3
Sun-G+ Rev.C
A5 size Chapter 3
97/11/14 pass 1
Printing on Single Sheets 3-5
To Next Page
Loading...
