Epson L1800 - Waste Ink Pad

L1800 Revision A
Disassembly And Assembly Disassembling the Printer Mechanism 79
Confidential
3.4.10 Waste Ink Pad
1. Remove the Printer Mechanism. (Refer to 3.4.4 Lower Housing / Printer
Mechanism (p.61).)
2. Remove the C.B.P. 3x8 screw that secures the Waste Ink Tube.
3. Remove the 11 Waste Ink Pads from the Lower Housing.
Figure 3-102. Removing the Waste Ink Pads
4) C.B.P. M3x8
(6±1 kgf.cm)
Waste Ink Pads
 Route the Waste Ink Tube as shown below.
Figure 3-103. Positions of Waste Ink Tubes
 Referring to Figure 3-104, correctly install the Waste Ink Pads.
Figure 3-104. Installing the Waste Ink Pads
A D J U S T M E N T
R E Q U I R E D
After replacing or removing the Waste Ink Pads and the Waste Ink
Pad, always make the required adjustments referring to the
following.
 “Chapter 4 Adjustment (p.109)”
Waste Ink Tubes
1
2
1
2
3
4
Installation
Order
Installation
Order