Epson LX-810 User Guide

Cut-Sheet Feeder
4. Insert the paper along the left paper guide. Then adjust the
right paper guide to match the paper width. Make sure that the
paper can move freely up and down.
5. Push the rear tabs on both paper guides backward to clamp the
paper against the guide rollers.
A new sheet of paper loads automatically whenever a printable
character or line feed command is sent to the printer while the ON
LINE light is on.
Note: Run the self test in the cut-sheet feeder mode. The
printer counts the number of lines on the page in l/6-inch line
spacing and prints out this number at the bottom of the first
test page. Use this number to set the lines-per-page with your
software.
Using the Printer Options
4-5

Epson LX-810 Specifications

General

Print Method	Impact dot matrix
Number of Pins	9
Character Sets	96 characters (USASCII)
Line Spacing	1/6 inch
Paper Path	Rear
Interface	Centronics parallel
Noise Level	55 dB (A)