Epson LX-810 User Guide

Interface Boards
6. Insert a screwdriver into the openings on the underside of the
printer. Gently push the screwdriver up, and press the handle
of the screwdriver toward the back of the printer to release the
clips on the case.
7. Partially raise the upper case, taking care not to strain the flat
cable attached to the control panel.
8. Carefully disconnect the flat control panel cable from the
connector labelled CN3 on the main board.
Using the Printer Options
4-19

Epson LX-810 Specifications

General

Print Method	Impact dot matrix
Number of Pins	9
Character Sets	96 characters (USASCII)
Line Spacing	1/6 inch
Paper Path	Rear
Interface	Centronics parallel
Noise Level	55 dB (A)