Interface Boards
4. If you have the #8148 or #8165 interface boards, set the
interface DIP switches according to the accompanying manual.
Note: If you have the #8143 interface board, you can select
baud rates from 75 to 9600 BPS (Bits Per Second). (Make sure
you use the bit rate selection table for printers with buffers in
the #8143 interface manual.)
5. Reattach the upper case as described next.
Attaching the upper case
1.
Fit the hinges of the upper case into the openings in the lower
case; then partially lower the upper case.
CAUTION: Take care not to pinch the FG wire between
the upper and lower cases.
Using the Printer Options
4-23
To Next Page
Loading...
