112 Handling
7.2.1.2 No Roll Paper (PAPER OUT) LED
The PAPER OUT LED flashing pattern is as follows.
7.2.1.3 Error (ERROR) LED
Note:
If an unrecoverable error occurs, turn the power off quickly.
When the error status occurs, stop all of the operations (printing, feeding, autocutting, drawer driving,
etc.)
You may choose to make the printer status BUSY or not depending on the memory switch setting. (Refer
to the "Memory Switch Settings" on page 44 and "Error Code" on page 113.
Item Specifications
LED color Red / Orange (TM-L90: 4** models)
ON states On Roll paper near end (only small amount of paper left on roll) or paper end (no paper
left) detected
Off Plenty of paper left on roll
Blinking TM-L90: Waiting for self-test status, or waiting for macro execution
status
TM-L90 Peeler Model: Waiting for self-test status, waiting for macro execution
status, or waiting for label removal
After removing the issued label, if the PAPER OUT LED
continues flashing, the label peeling sensor may be
reacting to direct sunlight or the like. Press FEED button
once.
Error (ERROR) LED
Item Specifications
LED color Red / Orange (TM-L90: 4** models)
ON states On Offline (except during paper feeding using the FEED button and during test printing, and
in the error state)
Off Normal condition
Blinking Error state
Waiting for self-test status
Waiting for macro execution status
Waiting for label removal
(TM-L90 Peeler Model only)
Approx.320 ms
Approx.320 ms