118 Handling
7.2.2 The autocutter is jammed or the roll paper cover will not open (TM-L90
only)
1. Turn off the power.
2. Insert a flathead screwdriver into the groove shown in the figure, and push up the cover.
Note:
There is also a similar slot on the opposite side face. You can easily remove the cutter cover by lifting it
while pushing the printer cover out from both sides simultaneously.
3. Remove the cutter cover.
4. Use a ballpoint pen or tweezers to turn the knob in the direction of the arrow indicated until
you see the triangle in the window.
To Next Page
Loading...
