Appendix 125
TM-L90/TM-L90 Peeler Model Technical Reference Guide
Setting items of TM-L90 other than 4** models
See "Memory Switch Settings" on page 44 for the procedures for the memory switch setting
mode.
Setting Items
Options
* The initial setting is underlined.1st page 2nd page
1: Auto Cutter Install
, Uninstalled
2: Paper, Print Density 1: Monochrome [Print density set up]
70%, 75%, 80%, 85%, 90%, 95%, 100%
, 105%, 110%, 115%,
120%, 125%, 130%, 135%, 140%
2: Two color [Print density set up]
70%, 75%, 80%, 85%, 90%, 95%, 100%
, 105%, 110%, 115%,
120%, 125%, 130%, 135%, 140%
3: Basic Serial Interface Settings [Baud rate set up]
2400 bps, 4800 bps, 9600 bps, 19200 bps
, 38400 bps, 57600
bps, 115200 bps
[Data bits / Handshaking / Parity set up]
8 bits / DTR/DSR / none
8 bits / DTR/DSR / even
8 bits / DTR/DSR / odd
8 bits / XON/XOFF / none
8 bits / XON/XOFF / even
8 bits / XON/XOFF / odd
7 bits / DTR/DSR / none
7 bits / DTR/DSR / even
7 bits / DTR/DSR / odd
7 bits / XON/XOFF / none
7 bits / XON/XOFF / even
7 bits / XON/XOFF / odd
4: Advanced Interface Settings [Buffer Capacity / Receive Error / Handshaking Operation
(Busy Condition)]
4 Kbytes / prints '?' / Off-line or Receive buffer full
4 Kbytes / prints '?' / Receive buffer full
4 Kbytes / ignore / Off-line or Receive buffer full
4 Kbytes / ignore / Receive buffer full
45 bytes / prints '?' / Off-line or Receive buffer full
45 bytes / prints '?' / Receive buffer full
45 bytes / ignore / Off-line or Receive buffer full
45 bytes / ignore / Receive buffer full
6: Interface Reset Signal [Serial #25 / Serial #6]
Disable / Disable
Disable / Enable
Enable / Disable
Enable / Enable
7: Paper Width 38 mm, 58 mm, 60 mm, 70 mm, 80 mm
To Next Page
Loading...
