44 Setup
2.8 Memory Switch Settings
The printer has the following software switches, called memory switches, in the non-volatile
memory.
❏ Msw1, Msw2, Msw5, Msw7, Msw8
❏ Customized values
❏ Serial communication conditions
❏ USB communication conditions
Note:
Msw5, Msw7, and USB communication conditions are available only for TM-L90 4** models or TM-
L90 Peeler 39* models.
These settings can be made by the Memory Switch Setting Utility (see page 91), the Memory
Switch Setting Mode (see page 44), or ESC/POS commands.
For details of ESC/POS commands, refer to the “ESC/POS Command Reference”. For details on
how to obtain this manual, see "Introduction of Control Methods" on page 85.
For usage of the Memory Switch Setting Utility, refer to the user's manual of the utility.
For usage of the Memory Switch Setting Mode, see "Memory switches of TM-L90" on page 45 for
TM-L90 4** models, TM-L90 Peeler 39* models, or "Memory switches of TM-L90 Peeler Model"
on page 50 for TM-L90 other than 4** models, TM-L90 Peeler other than 39* models.
To Next Page
Loading...
