126 Appendix
Setting items of TM-L90 Peeler 39* models
See "Memory Switch Settings" on page 44 for the procedures for the memory switch setting
mode.
8: Other settings [Selection of the PAPER OUT LED status when a paper
near-end is detected]
On
, Off
[Recovery selection when paper layout error occurs]
DLE ENQ or cover open/close
DLE ENQ
11: Select label [Select automatic measurement of maximum length for
paper]
160 mm
, 300 mm
[Select moving to the print starting position when power is
turned on]
moves to starting position
does not move
Setting Items
Options
* The initial setting is underlined.1st page 2nd page 3rd page
1: Print Current Settings -
2: Print Density 1:
Monochrome
1: Density Sample 70%, 75%, 80%, 85%, 90%, 95%, 100%
, 105%, 110%, 115%,
120%, 125%, 130%, 135%, 140%
2: Density List 70%, 75%, 80%, 85%, 90%, 95%, 100%
, 105%, 110%, 115%,
120%, 125%, 130%, 135%, 140%
3: Serial
Interface
Settings
1: Baud Rate 2400 bps, 4800 bps, 9600 bps, 19200 bps
, 38400 bps, 57600
bps, 115200 bps
2: Parity None
, Odd, Even
3: Handshaking DTR/DSR
, XON/XOFF
4: Data Bits 7 bits, 8 bits
5: Data Receive Error Print "?", Ignored
4: Paper Width 80 mm
, 70 mm, 60 mm, 58 mm, 38 mm
To Next Page
Loading...
