EasyManuals Logo

Epson TM L90 Technical Reference Guide

Epson TM L90
212 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #59 background imageLoading...
Page #59 background image
Setup 59
TM-L90/TM-L90 Peeler Model Technical Reference Guide
6. As shown in the following figure, pull the end of the paper to the bottom of the square hole
above the manual cutter (label peeling sensor).
Note:
Matching the leading edge of the roll paper with the printed marks on the printer ensures that the fewest
possible labels are ejected automatically.
7. Pressing down the end of the paper, close the roll paper cover. The printer automatically
feeds the paper to the start position.
WARNING:
Do not close the roll paper cover with your finger still inside the roll paper cover.
Doing so may lead to injury.
8. Close the peeler cover and cut off the excess paper with the manual cutter.
2.9.3 Setting Paper Layout
Before printing, it is necessary to set the layout information for paper type and size in the
printer. Doing paper feeding or printing without this layout setting may result in a paper out
(no paper left) or an error. In all of the following cases, therefore, make layout settings before
use.
When using label paper for the first time (except when replacing label paper of the same
type)
When you change the paper type (full-surface label paper/receipt paper, label paper, receipt
paper with black mark)
When changing the size of the label paper
When you change the liner for one of different transmittance.
There are automatic and manual layout settings. The setting procedure is as follows.

Table of Contents

Other manuals for Epson TM L90

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Epson TM L90 and is the answer not in the manual?

Epson TM L90 Specifications

General IconGeneral
Maximum resolution203 x 203 DPI
Maximum roll diameter90 mm
Supported paper width37.5, 79 mm
RS-232 ports1
Standard interfacesRS-232
Connectivity technologyWired
Country of originChina
Dimensions (WxDxH)140 x 203 x 148 mm
Flash memory0.384 MB
Operating temperature (T-T)5 - 45 °C
Pallet width800 mm
Pallet height2600 mm
Pallet length1200 mm
Pallet width (UK)1000 mm
Quantity per pallet112 pc(s)
Quantity per pallet (UK)168 pc(s)
Quantity per pallet layer16 pc(s)
Quantity per pallet layer (UK)24 pc(s)
Package depth257 mm
Package width193 mm
Package height241 mm
Package weight2560 g
Quantity per pack1 pc(s)

Related product manuals