134 Appendix
Reliability
TM-L90
Life When printing labels 1,000,000 labels issued
(When the length of the label in the paper feeding direction is 25.4
mm {1"} through 63.5 mm {2.5"}. The value above corresponds to
approximately 30 km to 70 km {18.64 to 43.5 miles} of running length.
When printing labels whose length exceeds 63.5 mm, the label-
issuing life is 70 km {43.5 miles} of running length.)
DTM9502 (only for 4** models): 700,000 labels issued (1,000,000 labels
issued after cleaning the platen.)
When issuing receipts
(thickness type)
10,000,000 lines printed (3.75 mm {0.15"} for one line)
(The value above is calculated based on the printer using 15-line
feeding and 10-line printing repeatedly with a 145 m paper
thickness. The value above corresponds to approximately 60 km
{37.28 miles} of running length.)
When printing receipts 20,000,000 lines printed (3.75 mm {0.15"} for one line)
(The value above is calculated based on the printer using 15-line
feeding and 10-line printing repeatedly with 75 m of paper
thickness. The value above corresponds to approximately 120 km
{74.57 miles} of running length.)
Thermal head 150 million pulses
Autocutter When cutting receipts:
2,000,000 cuts (except for KF50, when the paper thickness is less
than 75 m)
1,200,000 cuts (for KF50 (KANZAN))
1,000,000 cuts (when the paper thickness is more than 75 m and
less than 145 m)
When cutting labels:
1,000,000 cuts (Cutting between the labels)
500,000 cuts (Cutting labels not die-cut. 1,000,000-cut is available
by cleaning the blade.)
Note: When cutting die cut labels, cut between the labels.
MTBF 360,000 hours
(when printing receipts with the ENTPD series)
(Failure is defined as a random failure occurring during the random
failure period.)
MCBF 70,000,000 lines printed
(when printing receipts with the ENTPD series.
This is an average failure interval based on failures relating to wear
out and random failures up to the life of 20,000,000 lines printed.)
To Next Page
Loading...
Need help?
General
