Appendix 135
TM-L90/TM-L90 Peeler Model Technical Reference Guide
The values in the above table are based on use of Epson specified paper.
Vibration resistance When packed: Frequency: 5 to 55 Hz
Acceleration: Approximately 19.6 m/s
2
{2 G}
Sweep: 10 minutes (half cycle)
Duration: 1 hour
Directions: x, y, and z
No external or internal damage should be found after the vibration
test, and the unit should operate normally.
Impact resistance When packed: Package: Epson standard package
Height: 60 cm {23.62"}
Directions: 1 corner, 3 edges, and 6 surfaces
No external or internal damage should be found after the drop test,
and the unit should operate normally.
When unpacked:Height: 5 cm {1.97"}
Directions: Lift one edge and release it
(for all 4 edges).
When the printer is not printing, no external or internal damage
should be found after the drop test.
Acoustic noise (operating) Approximately 53 dB (ANSI bystander position)
Note: The value as shown above is measured when the Epson
evaluation printing pattern is used. This value may be
different, depending on the paper to be printed, the print
duty, or the print conditions, such as the print speed or the
print density.
To Next Page
Loading...
