Epson TM L90 - Setting Items of TM-L90 Peeler Other than 39* Models

128 Appendix
Setting items of TM-L90 Peeler other than 39* models
See "Memory Switch Settings" on page 44 for the procedures for the memory switch setting
mode.
11: Label
Settings
1: Automatic measurement of
maximum length
160 mm, 300 mm
2: Moving to the print start position Disabled
, Enabled
12: Paper Feed
Settings
5: Select manual feed operation in
Continuous issue mode
Paper feed to the print starting position
, Paper feed to the
peel position
13: Other
Settings
2: Interface
Settings
1: Receive Buffer
Capacity
4 KB
, 45 bytes
2: BUSY Condition Receive Buffer Full or Offline
, Receive Buffer Full
3: Auto Line Feed Always disabled
, Always enabled
4: State to cancel
buffer BUSY
Not BUSY = 256 bytes
, Not BUSY = 138 bytes
5: Error Signal Enabled
, Disabled
3: Near-End LED Disabled, Enabled
4: Transmit the power ON
information
Does not transmit, Transmit
5: Recovery layout error DLE ENQ
DLE ENQ or Main cover open/close
DLE ENQ or press down PAPER FEED button
DLE ENQ or Main cover open/close or press down PAPER
FEED button
Setting Items
Options
* The initial setting is underlined.
1st page 2nd page
2: Paper, Print Density 1: Monochrome [Print density set up]
70%, 75%, 80%, 85%, 90%, 95%, 100%
, 105%, 110%, 115%,
120%, 125%, 130%, 135%, 140%
2: Two color [Print density set up]
70%, 75%, 80%, 85%, 90%, 95%, 100%
, 105%, 110%, 115%,
120%, 125%, 130%, 135%, 140%