80 Setting/Checking Modes
After information printing, the Mode selection guidance is printed again.
5. To finish, turn off the power, or select "Exit and Reboot Printer".
4.1.3 Memory Switch Setting Mode
Use the following procedure to start this mode.
1. Close the roll paper cover.
2. Turn on the power while pressing FEED button. Keep pressing the button until the ERROR
LED comes on.
After printing the current status, a Continuing self-test guidance is printed, and the PAPER OUT LED
flashes.
3. Hold down the FEED button (for at least one second) to shift to Mode selection.
Mode selection guidance is printed, and the PAPER OUT LED flashes.
4. After briefly (less than one second) pressing the FEED button twice, hold it down for at least
one second, and then select memory switch setting mode (Customize Value Settings).
A guidance for the Memory switch setting mode is printed, and the PAPER OUT LED
flashes.
TM-L90 TM-L90 Peeler
To Next Page
Loading...
