Epson TM L90 Technical Reference Guide

Setup 55
TM-L90/TM-L90 Peeler Model Technical Reference Guide
2.9 Paper Loading Method
WARNING:
Do not open the roll paper cover (for the TM-L90 Peeler Model, do not open the peeler
cover and the roll paper cover) during the operation. Doing so may damage the
printer.
Do not touch the manual cutter with your hands when installing or replacing roll paper.
Touching the manual cutter may result in injury.
For the TM-L90, when the printer is placed horizontally, the raised roll paper cover may
close suddenly depending on the inclining angle of the printer. Take care not to get
your finger caught in it.
Note:
Be sure to use roll paper that meet the specifications.
2.9.1 With TM-L90
1. Open the roll paper cover, using the cover open lever.
2. Pull out roll paper with little paper remaining and insert new roll paper, aligning the paper
with the guide, as shown below.
3. Close the roll paper cover; then cut off the paper with the manual cutter.
WARNING:
Be careful that your finger is not inside the printer when you close the cover
because you can get your finger caught inside.

Epson TM L90 Specifications

General

Maximum resolution	203 x 203 DPI
Maximum roll diameter	90 mm
Supported paper width	37.5, 79 mm
RS-232 ports	1
Standard interfaces	RS-232
Connectivity technology	Wired
Country of origin	China
Dimensions (WxDxH)	140 x 203 x 148 mm
Flash memory	0.384 MB
Operating temperature (T-T)	5 - 45 °C
Pallet width	800 mm
Pallet height	2600 mm
Pallet length	1200 mm
Pallet width (UK)	1000 mm
Quantity per pallet	112 pc(s)
Quantity per pallet (UK)	168 pc(s)
Quantity per pallet layer	16 pc(s)
Quantity per pallet layer (UK)	24 pc(s)
Package depth	257 mm
Package width	193 mm
Package height	241 mm
Package weight	2560 g
Quantity per pack	1 pc(s)