Epson TM L90 - Printing Position in Relation to Cutter Position (TM-L90)

Appendix 141
TM-L90/TM-L90 Peeler Model Technical Reference Guide
Printing Position in Relation to Cutter Position (TM-L90)
The TM-L90 printing position and cutter positions are shown in the following figure.
Printing Position in Relation to Cutter Position
Note:
The values in the figure are central values. Slackness and differences in paper type can result in differences
developing between central values and cutter paper cut position. It is important to allow for a certain
margin of error when setting cutter paper cut position.
When operating using the ESC/POS commands, some paper-related commands allow you to feed paper
backward after an autocut.
•Back feed maximum amount
Receipt (without black mark): Approximately 11.5 mm (back feed amount is fixed)
Receipt (with black mark): Approximately 10.5 mm
Die cut label (without black mark): Approximately 10.5 mm
Die cut label (with black mark): Approximately 10.5 mm
Label (no die cut) (without black mark): Approximately 11.5 mm (back feed amount is fixed)
Do not perform partial cutting and (one point left uncut) reverse feed together.
14
29