Product Overview 21
TM-L90/TM-L90 Peeler Model Technical Reference Guide
1.2.7 Mode Switch (TM-L90 Peeler Model Only)
With the TM-L90 Peeler Model, you can select the peeling issuing mode and continuous issuing
mode with the mode switch. The mode switch switches between the peeling issuing mode and
continuous issuing mode.
The mode switch is inside the top left of the printer when the roll paper cover is opened.
Note:
Be sure that the peeler cover and the roll paper cover are open when switching the modes. The
setting is effective when the power is turned on or the covers are closed. If the mode is switched
with the covers closed, the setting will not be changed.
Be sure not to use a ball point pen to switch the modes. A ball point pen can damage the switch.
To use the peeling issuing mode, move the mode switch to the right.
To use the continuous issuing mode, move the mode switch to the left.
To Next Page
Loading...
